Hydraulic Cylinder Storing

Hydraulic Cylinder Storing for Extended Period

The procedure for storing “Hydraulic Cylinders” for an extended period. So here's what I recommend,

• Always store fully retracted.
• Store indoors in a clean, dry area.
• Smear the internal surfaces of eye/clevis bushes or bearings with grease - particularly if they're steel.
• Protect any exposed chrome on the rod. Oil-impregnated tape such as Denso tape can be used for this purpose. Before applying, make sure the rod is fully retracted. If a product like Denso tape is applied to the rod when the rod is not fully retracted, subsequent retraction of the rod can result in damage to the rod seal.
• Plug the service ports with steel - Not plastic, plugs or blanking plates.
• Consider filling the cylinder with clean hydraulic oil through rod-end service port. Particularly if it is an expensive, large diameter or high pressure cylinder. I say "consider" because there are a few issues to understand before doing this.

If the cylinder is not filled with oil it will obviously be filled with air. If this air is not perfectly dry, then as ambient temperature decreases, the air can reach due point. This results in moisture forming on the inside of the cylinder tube. This can cause spot rusting and pitting of the tube surface, which will reduce the volumetric efficiency of the cylinder, the service life of the piston seal, and ultimately, the life of the tube itself.

Completely filling the cylinder with clean hydraulic oil prevents this from occurring, however there's a major caution with this. It's best illustrated by an example below.

Say a cylinder is prepared for storage during the winter months. When the cylinder is filled with oil, the ambient temperature is 10 degrees Celsius. A year and a half later, during the middle of summer, the same cylinder is set down beside the machine to which it is to be installed. In the heat of the midday sun the temperature of the cylinder rises to 40 degrees Celsius. Assuming an infinitely stiff cylinder, the pressure of the oil in the cylinder resulting from the rise in temperature can be approximated by the formula:

P (bar) = 11.8 x (T2 - T1)

So the theoretical pressure of the oil in the cylinder is now: 11.8 x (40 - 10) = 354 bar or 5134 PSI…..! When it comes time for the unsuspecting mechanic to crack loose the blanks on the service ports … well let's just say that's more excitement that he signed up for.

That said, cylinders CAN be safely filled with oil for storage provided you:

1. Check that the worst-case temperature rise in storage won't result in a static pressure that exceeds the cylinder's working pressure.
2. Only fill the cylinder when fully retracted and ONLY through the rod-end port. This avoids potentially dangerous Pressure intensification.
3. Use service port plugs or blanks that are rated for the cylinder's working pressure.
4. Attach appropriate warning tags to BOTH service ports.
5. Provide a means to check and vent any pressure before each of the service port blanks is removed

When it comes time to remove blanking plates or plugs - always assume there's a possibility the component contains oil under pressure. And take the necessary precautions

As you can see, this procedure is somewhat involved and so the decision to fill a cylinder with oil is something one has to weigh up based on the value of the cylinder and how long you expect it to be in storage.

In case someone does not have time or resource to follow and care the cylinders for extended period of storing due to any reason, then they have to manually check and operate cylinders (few cycles) periodically


Mohammed Arif, ME, MIET(UK), CEng